Microplex M204 Spezifikationen PDF herunterladen (Seite 19)

GETTING TO KNOW THE M204: Overview of Print Server Installation 11

Basic Novell Conﬁguration

PSERVER Setup

The following outlines the basic steps required to add a M204 to a Novell network

using a PSERVER setup and applies to any Netware version. The M204 replaces a

dedicated workstation running PSERVER.EXE or PSERVER.NLM so these are no

longer needed.

Once the unit is physically attached to the network, you need to:

1 Enter into a PCONSOLE session. PCONSOLE is used for the entire print setup.

2 Create a new queue.

3 Create a new print server. The name will be is M_xxxxxx where xxxxxx is the last

six digits of the Ethernet address as found on the bottom of the unit.

4 Add a new printer and type in the name of one of the eight default destinations on

the unit. (e.g. d1prn1, d2prn2, etc.) At the prompt for the type ﬁeld, select

DEFINED ELSEWHERE. If this is not available, choose PARALLEL.

5 Associate this printer with the queue deﬁned in Step 2.

6 Reboot the Print Server and wait about a minute for it to connect to the ﬁle server.

RPRINTER Setup

The following outlines the basic steps required to add a M204 to a Novell network

using a RPRINTER setup and applies to any Netware version. The M204 interacts

with an existing PSERVER running PSERVER.EXE or PSERVER.NLM.

Once the unit is physically attached to the network, you need to:

1 Enter into a PCONSOLE session.

2 Create a new queue.

3 Select an existing PSERVER and deﬁne a new remote printer. The printer name

can be anything but the type must be REMOTE OTHER/UNKNOWN.

4 Associate this printer with the queue created in step 2.

5 Exit PCONSOLE.

6 Restart PSERVER. (e.g. PSERVER.NLM)

7 Go to SYS:\LOGIN and create a directory named M_xxxxxx where xxxxxx is the

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 203 204

Keine Kommentare

Microplex M204 Spezifikationen Seite 19